Skip to content
Open 24 hours, 7 days a week
Red Wrench Company logo
Heat pump outdoor unit on a concrete pad beside a stucco home in New Mexico

HVAC Rebates and Tax Credits in New Mexico: What to Check

The federal credit is gone. This is what to check with PNM, New Mexico Gas Company and EMNRD before you buy.

By Dominic Montoya, Owner of Red Wrench Company. Published , updated .

The federal 25C tax credit is over: it does not apply to HVAC equipment placed in service after December 31, 2025. HVAC rebates in New Mexico still exist through the state and utilities, but amounts conflict between sources and programs change. Use this checklist as of November 2026, then confirm every number before you buy.

The Federal Credit Ended December 31, 2025

Start here, because older articles and sales pitches still mention it. The 25C Energy Efficient Home Improvement Credit no longer applies to a furnace, AC or heat pump placed in service after December 31, 2025. The IRS page gives the end of 2025 as the cutoff. A heat pump installed in 2026 does not qualify.

If anyone quotes you a federal HVAC tax credit for 2026 equipment, ask them to show it to you in writing, and check it with a tax professional.

What HVAC Rebates in New Mexico Are Worth Checking?

State rebates, utility rebates and state tax credits remain, each with its own rules. Treat every amount in this table as a lead to verify, not a promise.

ProgramRuns throughWhat is reportedConfirm with
HEAR rebateEMNRDUp to $8,000 for a heat pump, for lower-income householdsEMNRD, CleanEnergy.nm.gov
PNM heat pump rebatePNMAbout $300 to $860, depending on the sourcePNM
PNM early AC replacementPNM$250 for SEER 13 or lower equipmentPNM
NMGC furnace rebateNew Mexico Gas CompanyAbout $325 to $500, commonly up to $425; a July 2026 release reports up to $625NMGC
State product tax creditEMNRD, then state taxesECAM lists $1,000 to $2,000 per productEMNRD
Geothermal tax creditEMNRD, then state taxes30% of cost, up to $9,000EMNRD

SEER is the seasonal cooling efficiency rating printed on older equipment. Your model plate or original paperwork will show it.

Homeowner reading the model plate on an older outdoor AC unit
Older efficiency ratings and model details decide some utility rebates, so check the plate first.

HEAR: Income-Qualified Heat Pump Rebates

HEAR, the Home Electrification and Appliance Rebate, targets lower-income households. EMNRD's Energy Conservation and Management Division says residents qualify by earning below 80% of Area Median Income, which varies by county, or by taking part in certain benefit programs. EMNRD lists up to $8,000 for a heat pump for space heating or cooling, says the program has begun, and sends applicants to CleanEnergy.nm.gov.

Three things to check first:

  • Installer rules. EMNRD says projects must be installed by a program-certified installer. Do-it-yourself work does not qualify. Confirm the current contractor list with EMNRD. Do not assume any company is on it, ours included.
  • Gas equipment. A May 2026 federal rule change may limit rebates for replacing gas equipment with electric. Ask about this if you heat with gas now.
  • Timing. The rebate applies as a discount at the point of sale, so settle it before work starts.

The heat pump is only one line. EMNRD's FAQ sets a limit for each measure and a $14,000 cap per household:

HEAR measureListed limit
Heat pump for space heating or cooling$8,000
Electrical panel$4,000
Electric wiring$2,500
Heat pump water heater$1,750
Insulation, air sealing and ventilation$1,600

The process runs online. Once you are approved, you receive a coupon to give the installer, the rebate goes to the contractor, and you pay the difference. EMNRD says the program ends four years after launch, without giving a date. A related Home Efficiency Rebates program is listed as coming, with its launch date still to be announced.

The two state pages differ on one point. EMNRD's FAQ says homeowners or renters, while the ECAM page says you must own and live in the home, so ask if you rent.

PNM and New Mexico Gas Company Rebates

Utility rebates depend on who sends your bill. Read it before you read anything else. PNM programs apply to PNM customers, and co-op customers need to ask their own co-op. That goes for homes in Bernalillo and everywhere else in the state.

PNM. Amounts conflict by source, from about $300 to $860 for a heat pump. PNM's rebates page also describes a Heating and Cooling Midstream program, where a contractor or distributor passes along a discount. An early AC replacement rebate of $250 has been listed for SEER 13 or lower equipment, with two AC rebates per account. Checks typically arrive 6 to 10 weeks after install. Rebate paperwork we saw for 2026 gives a December 31, 2026 postmark deadline, so ask about cutoffs if you buy late in the year. Verify all of it with PNM.

New Mexico Gas Company. Furnace rebates are cited from about $325 to $500, commonly up to $425. A company release dated July 8, 2026 reports up to $625 for eligible furnaces or boilers under a newly approved program, and older pages may still show the lower figures. Verify with NMGC before you pick equipment, since rebates often require a specific efficiency level.

Homeowner checking a utility bill at a kitchen counter next to a calculator
Your bill shows which utility program applies to your home.

State Tax Credits People Miss

New Mexico has its own credits, separate from the federal one that ended. EMNRD lists air source heat pumps among the Energy Conserving Products that can qualify, if they meet ENERGY STAR or equivalent values for the climate zone. The state's ECAM site lists $2,000 per product for low-income taxpayers and $1,000 for others, for taxable years before January 1, 2028, while funds remain. The same site advertises up to $10,000 for a qualifying heat pump by pairing the HEAR rebate with this credit, which is a ceiling for a qualifying household and not a typical result.

Geothermal systems have a separate credit, listed at 30% of purchase and installation cost up to $9,000, with accredited installer rules. Both run through a certificate from EMNRD that you then use on your state return. Annual caps can apply. Ask EMNRD and your tax preparer how any of this interacts with a rebate.

What We Tell Customers Before They Count on a Rebate

Rebate money should be the bonus on a good decision, not the reason for it.

  1. Price the job without the rebate. If the numbers only work with it, wait until it is confirmed.
  2. Get the requirements before you pick equipment. Efficiency tiers and installer rules can rule out a unit after the fact.
  3. Keep the invoice and AHRI documentation. AHRI paperwork shows that the outdoor and indoor units are a rated match at a stated efficiency.
  4. Ask who files. Some rebates want a form from you, others from the installer.
  5. Check the date. Rules can change between your quote and your install.

We size new systems with a Manual J and put the model numbers on the written quote, which is what you need to check any of this.

Should You Wait for a Rebate? The Honest Trade-Offs

Rebates can pull a buyer toward the wrong decision as easily as the right one. Weigh these before you plan around one.

  • Waiting or replacing now. A working system can wait for a confirmed answer. A failed one in July cannot, and a few hundred dollars is rarely worth weeks without cooling.
  • A listed installer or your preferred one. Program rules narrow your choice of contractor. A well-designed job can be worth more than a rebate tied to a weaker one, and the reverse can also be true.
  • A higher tier or a lower price. A rebate may not cover the price gap between efficiency tiers. Compare the quotes after the rebate, then set the difference against your bills.
  • Electric or gas. A large rebate can make a heat pump look like the obvious pick. Fuel, ducts and panel work still decide whether it fits your home.
Folder of HVAC installation paperwork on a kitchen table
An invoice and a rating certificate are the two papers most rebate programs ask for.

Check, Confirm, Then Buy

Treat 2026 like a year of moving parts. The federal credit is gone, while state and utility programs are open to change, so a phone call before you sign beats any article, including this one.

When you are ready, we can quote heat pump installation, furnace replacement or AC replacement with the details a rebate form asks for. Estimates are free and in writing. Call (209) 563-1270.

Common questions

Is there a federal tax credit for a new furnace or heat pump in 2026?

No. The federal 25C credit does not apply to equipment placed in service after December 31, 2025. Any 2026 install misses it. New Mexico state credits and rebates are separate, so check those with EMNRD and your utility before you buy.

Can I combine a PNM rebate with a HEAR rebate?

Maybe. Reports say state rebates cannot be combined for the same measure, and utility rules differ. Ask EMNRD and PNM directly, in writing if you can, and get the answer before you sign. Your tax preparer can address how a state credit fits alongside either one.

Does HEAR pay for an electrical panel or wiring?

It can. EMNRD lists up to $4,000 for a panel and $2,500 for wiring for qualifying households, inside the $14,000 household cap. A heat pump job that needs panel work may be able to use both. Get approved before work starts, since the coupon goes to the installer and the rebate comes off the price rather than arriving later.

When do New Mexico HVAC rebates and credits end?

It varies by program. EMNRD says HEAR ends four years after launch without naming a date, and the product tax credit runs for taxable years before January 1, 2028, while funds remain. Utility programs reset on their own schedules, and PNM paperwork for 2026 shows a December 31 postmark. Check each one before you commit to a purchase date.

Rather have someone look at it?

Call any hour. You get a straight answer, a free written estimate and the price before the work starts.

Red Wrench Company, 5635 Paradise Blvd NW, Albuquerque, NM 87114, (209) 563-1270

Tap to Call (209) 563-1270